[Best Insurance company]

Hi all,

Need to renew my policy and wondered who everyone is using these days?

I saw a few posts in the spring, stating some amazing low premiums, but can't find how to get back to them!

Is the cover any good?

Thanks in advance.

[Mk3 Clover leaf alloys]

Is there much interest in clover leaf alloys these days? Some say they were the ugly ducklings.

I see a lot of cabbies with non-genuine wheels but not so many original cars.

There are a few sets of clover leafs on the web ranging from £30 to £450! What is their true value either aged or refurbished?

Do you think it is right to paint them black and polish the rims or should they be original silver in colour?

[Power hood motor refurbishment or for sale?]

Agreed. Check its the motor first.

Check the voltage across the pump terminals when operating it. (Pump connected).  You should have just under battery voltage if the wiring is ok.

Cheers

[Fluid Level Advise?]

Fluid must have gone somewhere. I would check for  leaks from the pump and the rams. 

Think the pump should be filled to half way.

Cheers

[Ignition problem]

Hi Ash.

There are a few known problems which it could be.

First I would check the output from the switch when it faults. If that's ok then bypass the imobiliser on the security ECU. These play up from time to time.

Failing that it could be the fusebox.

Hope this helps

Paul

[Help! engine trouble]

I was going to say warm up regulators used to play up on these. Then get the fuel mixture checked. 

Dont overlook the basics either. Plugs distributor cap and rotor arm?

Cheers

[The old Bodgers loom]

Hi Martyn,

The yellow wire is the accessory output for the radio. 

Hope this helps.

Cheers

[Replacement 1996 Sill Panels]

Hi Spinder.

I gave up looking and in the end made some from sheet steel.

Good luck on the search.

[Original cassette player and equaliser]

The two big terminals are the supply and earth. The outer pin is earth and the other one is the yellow switched live.

The smaller ones are the permenent live and the electric aerial output but I can't remember which one is which. Try powering it up and seeing which small one goes live as this will be the aerial one. The display will be blank until you get your permenent feed on.

Cheers

[Passenger window not working mk4]

Could be broken wires between the door and the a pillar. Pretty good place to look as that is where they flex from door opening. This can break them after a while.

Cheers.

[Heater resistor]

Hi Dave,

The resistor on the mk 4 is strapped to the motor itself.

Can only think of checking with a local parts factors to see if they can advise on availability.

Failing that I guess flebay may have a used motor with one attached?

Cheers

[Cabriolet mk5 diagnostic port]

Hi, depends on what gizmo you have got!

The two pin serial link is for the FDS2000 diagnostic PDU which was really dealer only kit back then. The three pin  plug is for the Star tester. Again dealer level but a lot more widely available. 

This is the early level stuff before the standardised 16 pin DCL connector for EOBD which came out around 1995.

If you can find a Star tester then make sure it is a three digit one as you will need this one for the later EEC4 engine management module fitted to your car.

Might be easier to ask at your local dealer if they still have a Star tester!!!

If you do find one then code 111 is all systems pass

Hope this helps.

Cheers 

Paul

[Cabriolet mk5 diagnostic port]

Hi, as you open the bonnet it will be hanging on the right hand side strut turret. There will be a bunch of three connectors. A black three pin, a black two pin for serial data and a blue two pin.

Cheers 

[Cabriolet mk5 diagnostic port]

It will do if it has an Efi engine. It is the old style star/led tester type. Should be on the n/s inner wing.

Cheers

[Car turning over slow when spark plugs are in]

Might be worth double checking the valve timing is right.

Cheers

[1997 escort 1.6 engine stalling]

Hi, I would check for fault codes and check for air leaks. Make sure the fuel pressure regulator vacuum hose is connected.

Cheers

[Mk7 fuel pump issue]

Nothing known that I know of.

Mine failed a couple of years ago as the multiplug corroded and the terminal broke off the pump.

I replaced it with a Bocsh pump which is the OE brand and has been fine since. I wonder if yours has done the same and the multi plug is still corroded causing a bad connection ?

You can just about get to the plug by lifting the rear seat. Might be worth tesing the voltage to the pump wires to rule out the wiring before dropping the tank again.

Cheers

[Idle and Revving]

Glad to hear all is well and thanks for the update. Perhaps the breather system changes with the model year. 

Happy cabriotleting

 

[Idle and Revving]

Hi Sharon, the T piece connects breather pipes at the back of the head on the passenger side.

The breather valve is an oil separator and there is no real way of testing it unfortunately. I would just replace it. 

Cheers

Paul

[Idle and Revving]

Hi Sharon.

So the t piece in a bit lower down then on your photos. As you look at the engine feel with your right hand around the the top of the gearbox to the back of the head. Then it's just below.

The carb cleaner must be getting in somewhere if it causes the engine speed to increase so you have definitely got an air leak. Fix this first as you may find you problem will be fixed.

Why do you want to replace the tps???

Regards 

Paul

 

[Idle and Revving]

Hi Sharon,

The pipes go around the back of the engine and there is a t piece which also splits and gives trouble.. this is worth a check.

The speed sensor is fitted on the gearbox where the cable attaches and the harness goes up on to the baulkhead to a triangular 3 pin multiplug. The purpose of it is to provide a digital square wave to the ecu to inform road speed. The idea being to avoid cutting out due to throttle snap shut. In other words the revs should hang up until the car stops. 

The problem with these hall effect sensors is they develop an internal fault which gives supply voltage interference to the ecu which in turn thinks the car is moving when it is not, thus giving the high idle speed. The only real way to diagnose it properly is to check for interference with an oscilloscope. 

You could disconnect the speed sensor for a bit and see if it cures it however the engine may cut out when slowing down.

Cheers

Paul

[Idle and Revving]

Hi Sharon,

Yes the valve is on the front of he crankcase and the pipe attaches to it. They just pull out with a pair of pliers. 

They are sometimes called clacker valves as they make a clacking noise when you shake them! I would just replace it.

Incidentally Cortinas had them too!

If you still have a problem then I would be looking at he speed sensor on the gearbox.

Let me know how you get on.

Cheers

[1990 mk4 cabrio window]

Hi!

Remove the door trim and the front runner for the drop glass.

It will come out then.

Cheers

[Problem with windows when close the door]

Hi. Take the door trim off and have a look. The bottom of the window runner is secured to the door frame near the bottom and is adjustable. Hopefully it may just be the securing screw come out.

Cheers

Paul

[Tennis Fuel Problem]

The relay should start the fuel pump running when the engine is cranking. 

On Mfi Escorts the purple pump relay was a very common fault so if providing an additional earth does not fix it I would be looking at the relay.

Cheers.